Have you ever wondered how GPS antennas work? In particular, how do active GPS antennas get power down the same wire that they use to send signal to the receiver? Wonder not, because [Tom Verbeure ...

If you had a few of these, you could even examine several antennas at similar times and conditions. The transmitter has its own GPS so it doesn’t require much configuration. You do need to set ...

As part of Orban Microwave's continued effort for innovation, a wide range of GNSS antennas has been developed that in addition to GPS L1, GPS L2 and GPS L5 covers the Galileo L1, E5 and E6 and ...

The LDCBS1X2 GPS antenna splitter is a one input two output power divider designed specifically for the GPS L1, L2 & GLONASS carrier frequencies. One of the output legs (J2) is DC-Blocked to prevent ...

via collar with gps transmitter. SIRF III Satellite chip with 1200 BAUD serial output was connected to a Tiny Arduino board, which took commands and sent position information over a low-cost, ...

In this research, a newly found model of a satellite onboard transmitter using a uniform circular array multiple-input multiple-output antenna was designed to operate at a carrier frequency of 12 GHz ...

The SparkFun SAM-M10Q GPS Breakout features the the SAM-M10Q chip-antenna module from u-blox ... It has a horizontal position accuracy of 1.5 m, max update rate of 18 Hz when transmitting with just ...

This is a spare transmitter dipole antenna used in the Space Surveillance Fence. The system's three transmitter stations each had many hundreds of these antennas. Located across the southern United ...

The new antenna installation is completed and tested. Our tower crew and Dielectric, the company that built the antenna, were on site Thursday, June 4, to test the antenna. Chief engineer Dan ...

A customer would like to confirm if the combined antenna radiation pattern in the azimuth plane for all the transmitter and receiver pairs together (TX[1-3]-RX[1-4]) at Figure 51 of the User's Guide ...